Product Description
A shaft driven Pitts Electro-magnetic Clutch will give you dependable hydraulic pump control.
Clutch Specifications:
- Power: 91 Watts
- Max RPM: 3000
- Volts: 12
- Max Static Torque: 1000 pounds-feet
- For Pump Shaft Size: C spline 1-1/4 inch 14 Tooth
Mounting Bracket 13256 recommended for new installations and when a bracket is needed for a replacement clutch (sold separately).
Pitts Clutch Catalog - Diagram for this clutch is on page 33.
Drive flange bolt pattern and pilot diameter on clutch are dimensioned to correlate with ""Spicer"" type 1410 series drive shaft flange connections.
Proper drive shaft selection is important. Consult with draft shaft manufacturer's specifications for each specific application requirement. Drive shaft alignment must be within 3 degrees.
Important Installation Step: Clutches require a short burnishing period to generate the rate torque. To burnish, install the clutch and run at 1000 to 1290 RPM. Cycle on/off at the rate of 5 seconds on - 5 seconds off for a total of 25 cycles.
